|
This class was held at the Founder's Building in Grapevine, TX. The class was taught by Bill Andrle and Russ Aikins. In the class photo above are
Bill Andrle (instructor), Bela Marton, George
Barson, Kelsey Downum, Sam
Creech, Ron Mathis, Tom Wingo, David Lippe, Hugh Slough, Tommy
Slough, Mike Brazil and John Erickson. Attending the class but not show
was Bob Langston. Russ Aikins (instructor) took the photo. |
 |
George Barson
performing drilling operation on his brass sanding wheel project
prior to tapping. |
 |
David Lippe is
checking his brass sanding wheel screw thread depth. |
 |
Russ Aikins (our
master instructor) and Bela Marton: Russ is showing Bela the proper
way to drill on the Jewelers Lathe. |
 |
Mike Brazil is busy drilling his brass sanding wheel project. |
 |
Kelsey Downum and Sam
Creech busy trying to finish their project while Hugh Slough is
monitoring their progress. |
 |
A view of the classroom. |
Return to Photo Gallery Index Page
Go to Classes & Seminars Page page.
Return to Chapter124 Home Page Page.